How to Clean Out Drain Pipes

Any sewage or water coming from the drain normally means that a blocked drain is causing a blockage somewhere in the main drain system. If there’s a clog elsewhere the drain can easily block again. A clogged drain, or a slow drain, is usually a signal of an underlying problem in your drain pipe. The sooner you can find out what’s wrong with your drain system the better.

Clean Out Drain

One cause of blocked drain pipes is if your sewer system is not properly sealed, especially the main sewer lines. An improperly sewn sewer line will leave any water or liquid entering the house through your drain pipe unprotected.

Another common problem with clogged drains is backed up sewage. Backed up sewers tend to leave some water behind after sewage is pumped away. This water has nowhere else to go so it tends to pool in a narrow space outside the home, such as around a toilet bowl, sink, or bathtub.

To clean out a blocked drain, the first step is to check the drain. If the drain is clear you have found the source of the problem. But if the drain is blocked, you need to work your way towards a clogged drain solution.

Start by taking a look at your pipes. Make sure they’re in good shape and that you’ve filled them with enough water. If your pipes are backed up or have a block, you need to get them back into their proper place. A clogged drain will result in your water being sucked down into the sewer. In turn the drain will be backed up further, which will allow more water into your house.

Clogged drains often happen when a person is working on their sewer system. This may be the case if the blockage is caused by tree roots or other things. If this is the case, the next step is to make sure that the area around the tree or obstruction is clear of debris. In this case, you’ll want to carefully remove the obstruction and clear the drain. It may be a simple task but you don’t want to take more risk than you have to. if you haven’t already checked the tree for roots.

After removing the obstruction, inspect the drain to ensure that it’s in working order. If you’re not sure, call a professional who specializes in pipe and drain repair. A professional will be able to tell you whether or not your pipes are in good condition and whether they need to be replaced.

Even when your main sewer pipes are in good working order, your drain pipes may still need to be cleaned out. In these cases you will need to do a self-installation to get the job done.

An easy and relatively inexpensive self-install installation is to use a plunger. Plunge the drain pipe out to a depth of about two inches. Work in small sections to avoid ripping the pipe apart or causing any damage. Once you’ve completed the entire length of the pipe you can use plumbers’ tape to hold it in place so that it doesn’t come loose.

Now Clean Out Drain it with the old one. Then, using plumbers’ tape seal the new drain with the help of a sealant to prevent water from leaking back into the house.

In addition to cleaning out drain pipes, you should also be able to keep them clean. If you need to have more than one pipe repaired or replaced, then you may have to call a plumber. But, as a rule, your plumber should not be required unless the pipes in question are in danger of leaking or are badly damaged.

Another cause of clogging is the build up of bacteria in the pipes. If you’re experiencing any signs of clogging, call your plumber immediately.

Leave a Reply

Your email address will not be published. Required fields are marked *